Honda Shadow TA200 2001 Manual page 64

4. LUBRICATION SYSTEM
LUBRICATION SYSTEM DIAGRAM
SERVICE INFORMATION
SERVICEll'FORMA110N
GENERAL
4-0
4-1
TROUBLESHOOTING
OIL PUMP
4-1
4-2
If the engine must be running to do some works make sure the area is well ventilated. Never run the engine in an
enclosed area. The exhaust contains poisonous carbon monoxide gas that may cause loss of consciousness and may
lead to death. Run the engine in an open area or with an exhaust evacuation system in enclosed area.
Used engine oil may cause skin cancer if repeatedly left in contact with the skin for prolonged periods. Although this
Is unlikely unless you handle used of/ on a dally basis, ft Is stlll advisable to thoroughly wash your hands with soap and
water as soon as possible after handling used oil. KEEP OUT OF REACH OF CHILDREN.
The oil pump can be serviced with the engine installed i n the frame.
The service procedures i n this section must be performed with the engine oil drained.
When removing and i n stalling the oil pump, use care not to allow dust or dirt to enter the engine.
If any portion of the oil pump is worn beyond the specified service limits, replace the oil pump as an assembly.
Aller lhe oil pump has been i n stalled, check lhat there are no oil leaks.
SPECIFICATIONS
Unit: mm (in)
ITEM STANDARD SERVICE LIMIT
Engine oil capacity
At draining 1.0 l i ter (1.1 US qt, 0.9 Imp qt)
--
At disassembly 1.2 l i ter (1.3 US qi, 1.1 Imp qt)
--
Recommended engine oil
HONDA 4-stroke oil or equivalent
motor oil
API service classification SE, SF or SG
--
Viscosity: SAE 1 OW-30
Oil pump rotor Tip clearance 0.15 (0.006) 0.20 (0.008)
Body clearance 0.15-0.21 (0.006-0.008) 0.40 (0.016)
Side clearance 0.03 - 0.12 (0.001 - 0.005) 0.15 (0.006)
TORQUE VALUES
Oil pump mounting screw
Oil pump cover screw
1
o
N·m (1.0 kgf·m, 7 l b t-tt)
3 N·m (0.3 kgf·m, 2.2 lbMt)
Engine oil level too low
Normal oil consumption
External oil leak
Worn piston ring or i n correct piston ring i n stallation
Worn valve guide or seal
Oil contamination
External oil leak
Worn piston ring or i n correct pislon ring i n stallation
Worn valve guide or seal
Clogged oil strainer screen
Right side only
Low oil pressure
Oil pump worn or damaged
Oil not change often enough
Oil pump drive sprocket broken
4-1