Honda Shadow TA200 2001 Manual page 81

FUEL SYSTEM
FLOAT CHAMBER
Install the pilot screw and return it to its original position
as noted during removal.
Perform the pilot screw adjustment i f new pilot screw i s
installed (page 5-16).
CAUTION:
Damage to pilot screw seat w/11 occur If the pilot screw Is
tightened against the seat.
Install the needle jet, needle jet holder, main jet and slow jet.
CAUTION:
Handle the Jets with care. They can easily be scored or
scratched.
Hang the float valve onto the float arm l i p.
Install the float valve, float and float pin.
FLOAT LEVEL INSPECTION
NOTE:
Set the float level gauge so thal it is perpendicular to the
float chamber face at the highest position of the float.
With the float valve seated and the float arm just touching
the valve, measure the float l e vel with the float level gauge.
TOOL:
Carburetor float level gauge
07401 -0010000
The float cannot be adjusted.
Replace the float assembly if the float l e vel is out of
specification.
Install a new 0-ring i n to the groove in the float chamber.
5-12
0-RING
SPRING
_ / \
NEEDLJET · · · 'Iii,
• -\
,.
· PILOT
SLOW JET -------
I
.
SCREW
NEEDLE JET HOLDER SPRING SEAT
-
0-RING
FLOAT CHAMBER