Honda Shadow TA200 2001 Manual page 229

HYDRAULIC BRAKE
Remove the boot from the master cylinder and master piston.
SNAP RING
Remove the snap ring.
TOOL:
Snap ring pliers 07914 - SAS0001
a
BOOT
PISTON
MASTER CYLINDER
SNAP RING
l
<::)
WASHER/
SPRING
\
\
ii,
I
Replace the master piston, spring, cups and snap ring as a
set whenever they are disassembled.
Be sure thal each part i s free from the dust or dirt before
reassembly.
Never allow contaminants (dirt, water, etc.) to get into an
open reservoir.
NOTE:
Clean the master cylinder, reservoir and master piston with
clean brake fluid.
Remove the master piston and spring from the master cylin-
der.
INSPECTION
Check the piston cups tar wear, deterioration or damage.
Check the master cylinder and piston for scoring, scratches
or damage.
Measure the master cylinder I . D ..
SERVICE LIMIT: 11.06
mm
(0.435 in)
Measure the master piston O.D ..
SERVICE LIMIT: 10.95
mm
(0.431 in)
14-13