Honda Shadow TA200 2001 Manual page 230

HYDRAULIC BRAKE
SCREWS
2 N·m (0.2 kgf·m, 1.4 l b t-tt) """'-----
--........
---....
ASSEMBLY
SNAP RING
PIVOT BOLT
BRAKE LEVER
/
RESERVOIR COVER
•- .. - ... - .. DIAPHRAGM
PIVOT NUT
i_ . .
6 N·m (0.6 kgf·m, 4.3 lbMt)
j \
\ FRONT BRAKE LIGHT SWITCH
\
SCREW
1 N·m (0.1 kg1·m, 7 l b t-tt)
NOTE:
WASHER
SNAP RING
t
(',) /
PISTON
I
I
I
MASTER
CYLINDER
Replace the master piston, spring, cups and snap ring as a
set.
Replace the boot it
i t
is wear, deterioration or damage.
Apply silicone grease to the boot inner surface.
Be sure that each part i s free from the dust or dirt before
reassembly.
CAUTION:
Coat the master piston and piston cups with clean DOT 3 or 4
brake fluid.
Install the spring onto the master piston end.
Install the master piston/spring and washer i n to the master
cylinder.
Do not allow the piston cup lips lo turn inside out.
Be certain the snap ring is firmly seated in the groove.
Install the snap ring into the groove in the master cylinder.
Apply silicone grease to the boot.
Install the boot into the master cylinder and the groove i n the
master piston.
a. . _ _
BOOT
SNAP RING
07914 - SAS0001
TOOL:
Snap ring pliers
CAUTION:
14-14