Honda Shadow TA200 2001 Manual page 108

CYLINDER HEAD/VALVES
CYLINDER HEAD COVER DISASSEMBLY
Remove the screw and the rocker arm shaft setting plate.
Remove the screw i n to the threaded hole i n the rocker arm
shaft and pull the shaft out of the cylinder head cover.
Remove the rocker arm .
Remove the other rocker arm shaft and rocker arm.
Clean off any sealant material from the cylinder head mount-
ing surface.
INSPECTION
PLATE
SCREW
Check the rocker arms and shafts for wear or damage.
If the rocker arm slipper surface is worn or damaged, check
lhe camshall cam lobe and oil passages.
Measure each rocker arm shaft 0.0.
SERVICE LIMITS: 11.93 mm (0.470 in)
Measure each rocker arm 1.0.
SERVICE LIMITS: 12.05 mm (0.474 in)
Subtract each rocker arm shaft 0.0. from the corresponding
rocker arm I.D. to obtain the rocker arm-to-shaft clearance.
SERVICE LIMIT: 0.08 mm (0.003 In)
CYUNDERI-EADREMOVAL
Remove the Camshaft (page 7-4).
Remove the cam tansioner slider pivot bolt and cam chain
guide.
Check the cam chain guide for excessive wear or damage.
Remove the rubber plug; do not the lose i t .
Remove the cylinder head socket boll and the washer, being
careful nol lo drop lhem i n lo lhe crankcase.
Remove the cylinder head.
Be careful not to damage the mating surface.
7-6
ROCKER ARM
/
'ROCKER ARM SHAFT
CHAIN GUIDE
RUBBER PLUG
t.