Figure 59: Connecting Fiber-Optic Cable To A Pic - Juniper M7i Hardware Manual

See Also
Related
Documentation
Copyright © 2019, Juniper Networks, Inc.
To install a PIC cable (see
Have ready a length of the type of cable used by the interface, as specified in
1.
Specifications for the M7i Router" on page
If the interface cable connector port is covered by a rubber safety plug, remove the
2.
plug.
Insert the cable connector into the cable connector port on the interface faceplate.
3.
Arrange the cable to prevent it from dislodging or developing stress points. Secure
4.
the cable so that it is not supporting its own weight as it hangs to the floor. Place
excess cable out of the way in a neatly coiled loop. Placing fasteners on the loop helps
to maintain its shape.
Verify that the FIC or PIC is functioning correctly by noting whether the normal function
6.
indicator LED is lit. The normal function indicator LED is usually green; for more
information, see the M7i Multiservice Edge Router Interface Module Reference.
You can also verify correct PIC functioning by issuing the
command, described in
Cables" on page 192.

Figure 59: Connecting Fiber-Optic Cable to a PIC

M7i Flexible PIC Concentrators (FPCs) Description on page 43
M7i PICs Description on page 46
Removing an M7i FIC or PIC Cable on page 163
Troubleshooting the M7i FIC or PICs on page 205
M7i Flexible PIC Concentrators (FPCs) Description on page 43
Chapter 24: Replacing Line Card Components
Figure 59 on page 165):
45.
"Maintaining the M7i FIC and FIC Cables and PICs and PIC
"FIC
show chassis fpc pic-status
165