Figure 44: Connecting Fiber-Optic Cable To A Pic - Juniper M10i Hardware Manual

Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
All manuals and user guides at all-guides.com
Repeat the previous steps for any additional cables.
6.
If the PIC is offline (its failure indicator LED is lit), use one of the following methods
7.
to bring the PIC online:
Press and hold the PIC offline button until the status LED on the PIC faceplate
indicates normal functioning, which usually takes about 5 seconds. The LED is
usually green; for more information, see the M10i Multiservice Edge Router PIC Guide.
The offline button for each PIC is located on the HCM and is labeled with the PIC
slot number. The PICs in FPC
in FPC are located on the lower HCM.
1
Issue the following CLI command:
user@host> request chassis pic fpc-slot fpc-slot pic-slot pic-slot online
For more information about the command, see the Junos OS System Basics and
Services Command Reference.
The normal functioning indicator LED confirms that the PIC is online. You can also
verify correct PIC functioning by issuing the
described in "Maintaining the M10i PICs and PIC Cables" on page 81.

Figure 44: Connecting Fiber-Optic Cable to a PIC

Preventing Electrostatic Discharge Damage to an M10i Router on page 150
Connecting M10i PIC Cables on page 63
M10i PICs Description on page 8
Maintaining the M10i PICs and PIC Cables on page 81
Troubleshooting the M10i PICs on page 94
Chapter 15: Replacing M10i Hardware Components
are located on the upper HCM, and the PICs installed
0
show chassis fpc pic-status command
117