Replacing An Sfp; Figure 37: Connecting Fiber-Optic Cable To A Pic - Juniper M10i Hardware Manual

M10i Internet Router Hardware Guide
6.
7.

Figure 37: Connecting Fiber-Optic Cable to a PIC

Replacing an SFP

Small form-factor pluggables (SFPs) are optical transceivers that can be removed
from a PIC (for more information, see
104
Replacing an SFP
Repeat the previous steps for any additional cables.
If the PIC is offline (its failure indicator LED is lit), use one of the following
methods to bring the PIC online:
Press and hold the PIC offline button until the status LED on the PIC faceplate
indicates normal functioning, which usually takes about 5 seconds. The LED
is usually green; for more information, see the M10i Internet Router PIC Guide.
The offline button for each PIC is located on the HCM and is labeled with
the PIC slot number. The PICs in FPC
the PICs installed in FPC
Issue the following CLI command:
user@host>request chassis pic fpc-slot fpc-slot pic-slot pic-slot online
For more information about the command, see the JUNOS System Basics and
Services Command Reference.
The normal functioning indicator LED confirms that the PIC is online. You can
also verify correct PIC functioning by issuing the
command described in "Maintaining PICs and PIC Cables"
0 are located on the upper HCM, and
are located on the lower HCM.
1
show chassis fpc pic-status
"Physical Interface Cards (PICs)"
on page 74.
on page 10).