Reinstalling Components In The T640 Chassis; Figure 81: Installing The Router In The Rack - Juniper T640 Hardware Manual

Hide thumbs Also See for T640:

Table of Contents

Documentation

Reinstalling Components in the T640 Chassis

This illustration depicts the router being installed in a four-post rack.

For an illustration of the mounting hardware required for an open-frame rack,

Figure 62 on page

T640 Preventing Electrostatic Discharge Damage on page 506

T640 Router Installation Summary on page 151

Installing the T640 Router Using a Mechanical Lift on page 170

T640 Installation Safety Guidelines on page 511

After the T640 chassis is installed in the rack, you reinstall the removed components

before booting and configuring the router. The following procedures describe how to

reinstall components in the chassis, first in the rear and then in the front:

Reinstalling the T640 Standard or Quiet Rear Fan Tray on page 196

Reinstalling the T640 SCGs on page 197

Chapter 19: Installing the T640 Router Without a Mechanical Lift

Table of Contents