Reinstalling Components In The T640 Chassis; Figure 73: Installing The Router In The Rack - Juniper T640 Hardware Manual

Hide thumbs Also See for T640:

Table of Contents

Documentation

Reinstalling Components in the T640 Chassis

This illustration depicts the router being installed in a four-post rack.

For an illustration of the mounting hardware required for an open-frame rack,

Figure 56 on page

T640 Preventing Electrostatic Discharge Damage on page 386

T640 Router Installation Summary on page 85

Installing the T640 Router Using a Mechanical Lift on page 102

T640 Installation Safety Guidelines on page 390

After the T640 chassis is installed in the rack, you reinstall the removed components

before booting and configuring the router. The following procedures describe how to

reinstall components in the chassis, first in the rear and then in the front:

Reinstalling the T640 Standard or Quiet Rear Fan Tray on page 124

Reinstalling the T640 SCGs on page 125

Chapter 10: Installing the T640 Router Without a Mechanical Lift