Setting The Program Execution Order - Mitsubishi Electric M800W Series Connection And Set Up Manual

M800W/M80W Series Connection and Setup Manual
23 Sequence Program Writing

23.5.4 Setting the Program Execution Order

When creating the sequence programs with the multi-program method, the execution method and execution order of
each sequence program must be set. This operation is carried out before the sequence program is executed with the
CNC controller. The parameter file must be written to the CNC controller.
For details on each setting item, refer to the "PLC Programming Manual".
(Note) If this operation is not completed when using the multi-program method, an error will occur when RUN is
executed in the sequence program.
(1) Select the [Program] tab
(2) Select the sequence program name to be registered for execution from the program list on the left of the following
screen, and then press the "Insert" button. Select the execution mode from the registration program list on the right
side. After registering all sequence programs to be executed, click on [End].
IB-1501268-K 462