Sd Interface (Control Unit, Side Memory I/F Unit); Lan Interface (Control Unit, Personal Computer Unit) - Mitsubishi Electric M800W Series Connection And Set Up Manual

Hide thumbs Also See for M800W Series:
Table of Contents

Advertisement

M800W/M80W Series Connection and Setup Manual
4 General Specifications

4.21.2 SD Interface (Control Unit, Side Memory I/F Unit)

Standards
Transfer speed
Capacity
Number of free ports Control unit × 1, Side memory I/F unit × 1
(Note 1) SDXC is not supported.
(Note 2) Side memory I/F unit is only for 19-type display unit.
(1) Precautions for use of commercially available SD card
MITUBISHI will not provide performance guarantee and maintenance for commercially available SD card, mini SD
card or micro SD card (requires converting adapter). In case of using one of them, careful performance check must
be required by the machine tool builder.
Commercially available devices may not be compatible with MITSUBISHI units or suitable FA environment for
temperature- or noise-wise.
(2) Precautions for insertion/removal of SD card
When inserting/removing an SD card, turn the MITUBISHI device's power OFF. Do not pull out the card or turn OFF
the power during access to the SD card. Failure to observe this could cause the memory contents to be erased.
In case of emergency, always perform backups by having your important data duplicate, etc. as MITUBISHI will not
guarantee the broken or lost data.

4.21.3 LAN Interface (Control Unit, Personal Computer Unit)

Standards
Data transfer speed
(Note)
Number of free ports Control unit × 1, Personal computer unit × 1
Max. cable length
(Note 1) Data transfer speed is the theoretical value on the standard, and the actual speed will be inferior to the value
listed above. The transfer speed may be restrained depending on the specification of the connected device.
(Note 2) When using half-duplex communication, the response time may become long depending on the opposite
device.
Use full-duplex communication to connect with the opposite device via a switching HUB.
(1) Precautions for selection of LAN cable
Make sure to select the LAN cables which are "category 5e or above" and "shielded". Cable wire material with
double shielded, which is appropriate for FA environment., is recommended.
SD/SDHC (Note)
According to the connecting SD card
32GB
1000BASE-T / 100BASE-TX / 10BASE-T
1000Mbps / 100Mbps / 10Mbps
100m
205
IB-1501268-K

Advertisement

Table of Contents
loading

This manual is also suitable for:

M80w seriesM850wM830wM80w

Table of Contents