Table of Contents
Advertisement
Date of
Manual No.
revision
Apr. 2016
IB(NA)1501268-C
(Continued from the previous page)
4.2 Environment Conditions [M80W]
4.4 Control Unit [M80W]
4.6 Display Unit [M80W]
4.8 Graphic Control Unit
4.9.1 Keyboard for 8.4-type Display Unit (FCU8-KB026)
4.9.2 Keyboard for 8.4-type Display Unit (FCU8-KB028)
4.9.3 Keyboard for 8.4-type Display Unit (FCU8-KB029)
4.9.4 Keyboard for 10.4-type Display Unit (FCU8-KB041)
4.9.5 Keyboard for 10.4-type Display Unit (FCU8-KB046)
4.9.6 Keyboard for 10.4-type Display Unit (FCU8-KB047)
4.9.7 Keyboard for 10.4-type Display Unit (FCU8-KB048)
4.12 Function Expansion Unit
4.13.2 PROFIBUS-DP (FCU8-EX563)
4.16 Synchronous Feed Encoder
4.17 Exclusive SD cards for MITSUBISHI CNC
5.3.6 Function Expansion Unit
7.5 Connecting with Graphic Control Unit
7.12 Connecting Device via Function Expansion Unit
7.13.2 Connecting I/O Device via PROFIBUS-DP
9 Connecting with Graphic Control Unit
11.6 Connecting with Graphic Control Unit
12.9 Connecting with Analog I/O Signal (FCU8-DX202)
14.4 Connecting with Encoder (Manual Pulse Generator) I/F Expansion Unit
15 Connection of Synchronous Feed Encoder
16.2.1 FCUA-R050/R054 Cable
16.2.4 J010 Cable
16.2.12 J170 Cable
16.2.15 J221 Cable
29 Appx.2: Protection setting
- Chapter composition change
Title of chapter 6 was changed into "Precautions for Connecting"
Former 6.3 to 6.9 were changed into independent chapters (Chapter 7, 8, and 10 to 14)
Explanations for connection of drive unit in former 9.3 to 9.5 were moved to a new
chapter 7
Former chapter numbers 7 to 19 were changed into 16 to 27 due to chapters addition
and the change of chapter 6
Former 7.2 was moved to a new section 16.3.1
- Chapter number change
Chapter 17 was changed into Chapter 28
Appendix 1 to 3 were changed into Chapter 30 to 32
- Chapter title Change
Some of chapter titles were changed to correspond with M80W and Windows-less
Display
- Mistakes were corrected.
Revision details
Advertisement
Table of Contents
