Connecting With Drive Unit Mds-Em/Emh Series - Mitsubishi Electric M800W Series Connection And Set Up Manual

M800W/M80W Series Connection and Setup Manual
7 Connection of Control Unit

7.8.2 Connecting with Drive Unit MDS-EM/EMH Series

CAUTION
Connect the NC and the drive units by the optical communication cables. The distance between the NC and the
final drive unit must be within 30m and the specified bending radius (for wiring inside panel: 25mm, and for wiring
outside panel: 50mm) or more.
POINT
Axis Nos. are determined by the rotary switch for setting the axis No. (Refer to the manual of drive unit.) The axis
No. has no relation to the order for connecting to the NC.
(1) When using only MDS-EM/EMH-SPV Series
Connected
to the NC
Optical
communication
cable
Refer to the
instruction
manuals of NC
for details.
CAUTION
Confirm that the TE2 (L+, L-) wiring is not connected to other power supply before turning the power ON.
MDS-EM/EMH-SPV3
Spindle:1st axis
Servo:2nd/3rd/4th axis
CAUTION
259
MDS-EM/EMH-SPV3
Spindle:5th axis
Servo:6th/7th/8th axis
CAUTION
IB-1501268-K