Control Unit Connection System Drawing; M800W - Mitsubishi Electric M800W Series Connection And Set Up Manual

M800W/M80W Series Connection and Setup Manual
7 Connection of Control Unit
The method for connecting to each unit and device from the control unit is explained in this chapter.

7.1 Control Unit Connection System Drawing

7.1.1 M800W

Control unit
DCIN
EMG
Windows-based display
GDI
RIO3
non-Windows-based display
GDI
RIO3
RIO1/RIO2
OPTH1/OPTH2
SIO
SKIP
AIO
Function
EXT1/EXT2
expansion unit
Communication
EXT3/EXT4
expansion unit
LAN
SD memory card
SD
RIO8
(Note 1) Use when installing an emergency stop switch in the electric cabinet. (Connection cable: J120 cable)
When not used, connect the terminal connector (G123 cable).
G123 terminal cable comes with the control unit.
(Note 2) For the connection of machine operation panel, refer to the chapter "Connection of Machine Operation Panel".
IB-1501268-K
J070/J071 cable
24VDC Stabilized
power supply
G123 terminal
Emergency stop (Note 1)
Personal computer unit
GDI
J303
cable
Operation panel I/O unit
RIO3
J210 cable
Graphic control unit
LAN2
J303 cable
Operation panel I/O unit
RIO3EXT
J210 cable
J210 cable
Remote I/O unit
J395/J396/G380 cable
Servo/Spindle drive unit
J030/J031 cable
RS-232C device
J100 cable
Skip input (Sensor input)
Analog IO, or
J220 cable
J026/J027 cable
5V manual pulse generator
Synchronous feed encoder, or
5V manual pulse generator
Network
J301 cable
Network
Energy
measuring units
Display unit
Display unit
246