Table of Contents
Advertisement
M800W/M80W Series Connection and Setup Manual
23 Sequence Program Writing
(b) For the user safety sequence
PC side I/F
Network No.
Station No.
Protocol
PLC side I/F
CPU mode
Ethernet port direct connection
IP address
Other station
Time out check (sec.)
Number of retry
Multi CPU
For the user safety sequence 1, select No. 1.
For the user safety sequence 2, select No. 2.
*1: The setting items are displayed by double-clicking the Ethernet board selection field.
*2: The setting items are displayed by double-clicking the CPU unit selection field.
*3: The setting items are displayed by double-clicking the other station (Single network) selection field.
■ SW8D5C-GPPW setting screen
(3) Press the [Connection test] button after completing the setting.
If the connection has succeeded, the message "Successfully connected with the Q26UDHCPU." will be displayed
and the multiple CPU connection status will be displayed at the bottom of the message. This display indicates
connection status for each project.
IB-1501268-K
Setting item
Ethernet board
1
1
TCP
CPU unit
QCPU (Q mode)
Not check
IP address of CNC
No other station designated
Arbitrary time (Approx. 10 sec. or more)
0
Setting content
458
Remark
*1
*1
*1
*2
*2
*2
*3
*3
Advertisement
Table of Contents
