Table of Contents
Advertisement
Date of
Manual No.
revision
Jun. 2020
IB(NA)1501268-K The descriptions of M800 Series/M80 Series were revised in response to S/W version
F1.
- The following chapters were added.
26.2.9 Behavior in Prohibited Area
27.3 Cyclic Error Compensation
33 Synchronous Control and Multiple-axis Synchronization Control
- The following contents were changed.
2.1.1 M800W, Windows-based Display (15-type)
2.1.2 M800W, Windows-based Display (19-type)
2.1.3 M800W, Non-Windows-based Display (10.4-type / 15-type)
2.2.1 2.2.1 M80W, Windows-based Display (15-type)
2.2.2 M80W, Windows-based Display (19-type)
2.2.3 M80W, Non-Windows-based Display (8.4-type /10.4-type /15-type)
3.1 Control Unit [M800W]
3.2 Control Unit [M80W]
3.20 Genuine Memory Card
3.23 List of Cables
4.1.1 Environment Conditions inside the Operation Panel
4.1.2 Environment Conditions inside the Control Panel
4.2.1 Environment Conditions inside the Operation Panel
4.2.2 Environment Conditions inside the Control Panel
4.11.2 FCU8-DX220 / FCU8-DX230 / FCU8-DX231 / FCU8-DX202 / FCU8-DX213 /
FCU8-DX213-1 / FCU8-DX654 / FCU8-DX654-1 / FCU8-DX651 / FCU8-DX408 /
FCU8-DX409
5.3.9 Machine Operation Panel
6.1.2 Precautions for Using Optical Communication Cable
7.1.1 M800W
7.8.1.2 Drive Unit Arrangement
11.1 Operation Panel I/O Unit Connection System Drawing
11.9 Connecting with Remote I/O Unit
12.1 Remote I/O Unit Connection System Drawing
12.5 Connecting with Operation Panel I/O Unit
16 Connection of Machine Operation Panel
16.2 Connecting with Power Supply
16.4 Connecting with Operation Panel I/O Unit
16.5 Connecting Emergency Stop Switch
16.6 Connecting with Sub Panel
18.2.4 G170 Cable
18.2.9 J023/J024/J025 Cable
18.2.10 J026/J027 Cable
18.2.14 J120 Cable
18.2.20 J291 Cable
18.3.1 Cable Wire and Assembly
18.3.3 CNP3EZ-2P/CNP3EZ-3P Cable
20.4 Setting Up without Connecting to the Motor/Drive Units at the Setup of Drive Unit
20.6.2 Connection and Station No. Setting on Remote I/O Unit
20.6.4.2 Arbitrary Device Assignment
23.4 Setting the Communication with GX Developer
23.8 Setting the Communication with GX Works2
23.11 Writing a Sequence Program to ROM with GX Works2
(Continue to the next page)
Revision details
Advertisement
Table of Contents
