Mitsubishi Electric M800W Series Connection And Set Up Manual page 309

M800W/M80W Series Connection and Setup Manual
7 Connection of Control Unit
[CC-Link cable connecting procedure]
(1) Remove the sheath of the CC-Link cable about 4cm.
4cm
Shield mesh
(2) Isolate the shield mesh and the wires coverd with shield tape.
Remove the shield tape from wires.
remove shield tape
twist shield mesh
(3) Insert the wires to the connector for CC-Link as below.
Inset
Connector for CC-link
1pin Blue wire
2pin White wire (cover notation: DB W)
3pin Yellow wire (cover notation: DG Y)
4pin No connect
5pin Shield wire (cover notation: SLD)
(4) Press the connector with the use of a pliers.
Check that the clamp point is flat to the connector for CC-Link.
IB-1501268-K
CC-Link cable
wires
(cover notation: DA B)
pliers
270