Table of Contents
Advertisement
CAUTION
For items described as "Restrictions" or "Usable State" in this manual, the instruction manual issued by
the machine tool builder takes precedence over this manual.
Items that are not described in this manual must be interpreted as "not possible".
This manual is written on the assumption that all the applicable functions are included.
Some of them, however, may not be available for your NC system.
Refer to the specifications issued by the machine tool builder before use.
Refer to the Instruction Manual issued by each machine tool builder for details on each machine tool.
Some screens and functions may differ depending on each NC system (or version), and some functions
may not be possible. Please confirm the specifications before starting to use.
Refer to "Smart safety observation" (BNP-C3072-022) for details about the connection with safety
observing I/O device.
To protect the availability, integrity and confidentiality of the NC system against cyber-attacks including
unauthorized access, denial-of-service (Dos) (*1) attack, and computer virus from external sources via a
network, take security measures such as firewall, VPN, and anti-virus software.
(*1) Denial-of-service (Dos) refers to a type of cyber-attack that disrupts services by overloading the system
or by exploiting a vulnerability of the system.
Mitsubishi Electric assumes no responsibility for any problems caused to the NC system by any type of
cyber-attacks including DoS attack, unauthorized access and computer virus.
The numerical control unit is configured of the control unit, display unit, personal computer unit, operation board
(operation panel I/O unit), servo drive unit, spindle drive unit, power supply unit + driver, servomotor, spindle motor,
etc.
In this manual, the following items are generically called "controller".
- Control unit
- Display unit
- Personal computer unit
- Operation board (operation panel I/O unit)
- Numerical control unit peripheral devices (input/output unit, safety unit)
In this manual, the following items are generically called "drive unit".
- Servo drive unit
- Spindle drive unit
- Power supply unit + driver
In this manual, the following items are generically called "motor".
- Servo motor
- Spindle motor
Also refer to the manuals on "Manual List" as necessary.
Advertisement
Table of Contents
