Table of Contents
Advertisement
M800W/M80W Series Connection and Setup Manual
18 Cable
18.3.7 DG30 Cable
Max. cable length: 10m
Application: Battery cable
(drive unit - battery box, drive unit - drive unit)
Drive unit side connector
Contact: SPHD-001G-P0.5
18.3.8 G380 Cable
Max. cable length: 30m
Application: Optical communication cable
for wiring between drive units (outside panel)
for optical communication repeater unit
Use when the cable length is 10m or more to 30m or less.
[OPT]
Connector: CF-2D103-S
Manufacturer: Japan Aviation Electronics
2-core cable (section with reinforced sheath)
2-core cable (section without reinforced sheath)
(Note 1) Binding the cables too tight with tie-wraps could result in an increased loss or a disconnection. Use a
cushioning material such as a sponge or rubber when bundling the cables and fix so that the cables do not
move. (Clamp material for reference: KITAGAWA INDUSTRIES CKN-13SP)
(Note 2) Never bundle the cables with vinyl tape. The plasticizing material in the vinyl tape could cause the PCF cable
reinforced sheath to damage.
(Note 3) Loop the excessive cable with twice or more than the minimum bending radius.
(J.S.T)
Connector: PAP-02V-O
BT
1
LG
2
Section with reinforced sheath
OPT
OPT
1
2
Wire material: Hard clad type PCF optic cable
Manufacturer: Oki Electric Cable
Cable
Drive unit side connector
(J.S.T)
Connector: PHR-2-BL
Contact: SPH-0022GW-P0.5S
1
BT
2
0.2mm
LG
2
OPT
Section without reinforced sheath
OPT
1
2
Minimum bending radius: R
397
50mm
25mm
IB-1501268-K
Advertisement
Table of Contents
