Table of Contents
Advertisement
M800W/M80W Series Connection and Setup Manual
37 Data Backup and Restoration
(5)
Move the cursor to select the file. Press
the [INPUT] key.
The cursor moves as follows:
[ ↓ ] key:
Auto1 -> Auto2 -> Auto3 -> Manual -> Auto1 ...
[ ↑ ] key:
Auto1 -> Manual -> Auto3 -> Auto2 -> Auto1-> ...
(6)
Press [Y], [y] or [Input].
(7)
The restoration is completed
without error.
[Note]
(1) When the restoration fails, perform the restoration again otherwise it may cause an abnormal operation.
(2) Restored data writes over the previous absolute position data. Carry out the absolute position detection again after
restoration.
(3) If you attempt to restore custom data on a Windows-based display while custom data has been installed in the NC,
the message "File access error" appears which may disable restoration. Thus, use the integrated installer to delete
custom data from the NC before restoring custom data.
IB-1501268-K
The operation message "OK?
(Y/N)" appears.
<Note>
- If there are no files at the position where the cursor moved
to, the operation message "Select directory to restore"
appears. Select the file again and then press the [INPUT]
key.
The restoration starts.
"Executing" and "*" are displayed for the state of file
under processing.
<Note>
- If PLC is in operation, the "PLC running. Does it stop? (Y/
N)" message is displayed. Press [Y], [y] or [INPUT] to
continue the restoration.
- If the tool data is being sorted, the operation message
"File access error" is displayed and the restoration cannot
be executed.
- For the custom data, the restoration cannot be canceled
during its execution.
The states of restoration-complete
files turn to "Complete", the operation message
"Restore complete"
appears.
"Unexecute" is displayed
for the file which could not be restored, for instance,
due to the
nonexistence of the file.
612
Advertisement
Table of Contents
