Connecting The Control Unit And A Personal Computer - Mitsubishi Electric M800W Series Connection And Set Up Manual

Hide thumbs Also See for M800W Series:
Table of Contents

Advertisement

M800W/M80W Series Connection and Setup Manual
23 Sequence Program Writing
(5) Take a note of the displayed IP address and subnet mask.
(6) Set the following addresses. (Note)
(Example)IP address: 192.168.200.2
Subnet mask: 255.255.255.0
(Note)
In the section "23.2.1 Confirming the IP Address for CNC", set an IP address in the range of
"192.168.200.1" to "192.168.200.254", but do not use "192.168.200.1".
Note that when other CNC and devices are connected on the same network, be careful not to duplicate
the address with other CNC and devices.
(7) Click [OK] and close all the windows.

23.3 Connecting the Control Unit and a Personal Computer

Connect a personal computer, which has GX Developer or GX Works2 installed, to the control unit.
LAN
(Note 1) It is recommended to use GX Developer Version 8.114U (SW8D5C-GPPW) and later.
(Note 2) It is recommended to use GX Works2 Version 1.570U and later.
(Note 3) Use a cross LAN cable for the communication.
(Note 4) Carry out the Ethernet communication setting (IP address and so on) on the personal computer before
connecting it to NC.
IB-1501268-K
GX Developer
/GX Works2
456

Advertisement

Table of Contents
loading

This manual is also suitable for:

M80w seriesM850wM830wM80w

Table of Contents