Backlash Compensation - Mitsubishi Electric M800W Series Connection And Set Up Manual

M800W/M80W Series Connection and Setup Manual
29 Setting the Backlash Compensation

29.1 Backlash Compensation

Travel amount of a machine table may become less than the commanded amount due to the error (backlash) caused by
reversal of the direction of the axis.
The backlash compensation is a function which automatically adds compensation amount to the travel amount when the
direction of the axis is reversed.
+
Machine table
There are two types of backlash compensation as follows.
(1) G0 backlash (#2011 G0back)
Compensation amount that is used when an axis moved at the rapid traverse speed (G0).
Compensation amount is also measured at rapid traverse speed.
(2) G1 backlash (#2012 G1back)
Compensation amount that is used when an axis moved at cutting feedrate (G1, G2, G3).
Compensation amount to be set is measured using the most commonly used feedrate.
IB-1501268-K
-
Ball screw
(Motor)
Backlash
544