Table of Contents
Advertisement
M800W/M80W Series Connection and Setup Manual
23 Sequence Program Writing
(b) For the user safety sequence
PC side I/F
Network No.
Station No.
Protocol
PLC side I/F
CPU mode
Ethernet: direct port connection and
connection via hub selection
IP address
IP input format
Other station setting
Check at communication time (sec.)
Retry times
Multi CPU designated
Select the first machine for the user safety sequence 1.
Select the second machine for the user safety sequence 2.
(*1)
Double-click [Ethernet Board] to display the setting item.
(*2)
Double-click [Ethernet Module] to display the setting item.
(*3)
Double-click [Other Station (Single network)] to display the setting item.
■ Transfer Setup Connection 1 screen
(3) After setting the connection, press [Connection Test].
If connection is successful, the message "Connected with Q26UDHCPU" is displayed with the multi-CPU
connection status underneath, which indicates the connection status of each project.
Item
Ethernet Board
1
1
TCP
CPU unit
QCPU (Q mode)
Connection via hub
IP address of CNC
Decimal
No other station specified
Arbitrary time (approximately 10 seconds
and longer)
0
467
Setting
Note
(*1)
(*1)
(*1)
(*2)
(*2)
(*2)
(*2)
(*3)
(*3)
IB-1501268-K
Advertisement
Table of Contents
