Table of Contents
Advertisement
M800W/M80W Series Connection and Setup Manual
23 Sequence Program Writing
23.8 Setting the Communication with GX Works2
To create the machine sequence and user safety sequence of the CNC, use the Mitsubishi integrated FA software GX
Works2, which is the PLC development tool for the Mitsubishi PLC MELSEC Series.
Machine sequence:
User safety sequence:
When using GX Developer, refer to "Setting the Communication with GX Developer".
(1) Start the setting screen by the following operation in the navigation window on GX Works2.
Select [Connection Destination], then double-click [Current Connection].
(2) Set the following items in the order of the list.
(a) For the machine sequence
PC side I/F
Network No.
Station No.
Protocol
PLC side I/F
Type name
Station No.
IP Address
IP Input Format
Station No. <-> IP information
Other Station Setting
Check at communication time (sec.)
Retry times
Network Communication Route Detailed setting
of Ethernet
Access to Ethernet module set on PCL side I/F
(*1)
Double-click [Ethernet Board] to display the setting item.
(*2)
Double-click [Ethernet Module] to display the setting item.
(*3)
Double-click [Other Station (Single network)] to display the setting item.
(*4)
Double-click [Ethernet] to display the setting item.
■ Transfer Setup Connection 1 screen
IB-1501268-K
Control circuit created to control the machine tools (ladder circuit)
Control circuit of the safety-related I/O observation created with the smart safety observation
function (ladder circuit)
Item
Ethernet Board
1
1
TCP
Ethernet Module
QJ71E71
1
IP address of CNC
DEC.
Automatic Response System
Other Station (Single Network)
Any time period (from about 10 seconds)
0
Setting
466
Note
(*1)
(*1)
(*1)
(*2)
(*2)
(*2)
(*2)
(*2)
(*3)
(*3)
(*4)
Advertisement
Table of Contents
