Connecting With Emergency Stop Signal - Mitsubishi Electric M800W Series Connection And Set Up Manual

M800W/M80W Series Connection and Setup Manual
9 Connection of Graphic Control Unit

9.3 Connecting with Emergency Stop Signal

Connect the emergency stop switch to EMG connector of the graphic control unit.
Graphic control unit
Graphic control unit
R EMGIN
LG
Emergency stop input circuit
<Related items>
Cable drawing: "Cable: J120 Cable"
Connector pin assignment: "General Specifications: Graphic Control Unit" (EMG connector)
<When not using graphic control unit side emergency stop input signal (EMG)>
When not using graphic control unit side emergency stop input signal (EMG), such as when control unit side
emergency stop input signal (EMG) is used, invalidate the input signal by using terminal cable G123.
Note that G123 cable does not come with the graphic control unit. (G123 cable comes with the control unit.)
Graphic control unit
EMG
(Note) When installing emergency stop switch at operation panel and electric cabinet each, both emergency
stop input signals (EMG), the signal at the graphic control unit side and at the control unit side, can be
used.
IB-1501268-K
J120
EMG
+24V
FG
G123
Emergency
stop switch
Emergency
stop switch
286