Optional Unit (Memory Expansion Unit / Function Expansion Unit) - Mitsubishi Electric M70V Series Connection Manual

MITSUBISHI CNC
3 Installation

3.3.5 Optional Unit (Memory Expansion Unit / Function Expansion Unit)

(Note) For details on how to install the optional unit, refer to the installation procedure sheet attached to the optional
unit.
This chapter explains how to install optional unit alone as an example.
If installing memory expansion unit as a second optional unit, refer to the installation procedure sheet.
If installing multiple optional units, refer to the installation procedure sheet.
(1) Remove the ADONCCB connector's cover of the control unit.
(2) Connect the optional unit to the control unit's ADONCCB connector.
(3) Fix the optional unit with two screws (on the upper right and the bottom left) and mount the back cover.
[Back cover Installation]
(1) Insert the three tabs on the bottom edge of the cover into the
control unit.
94
(2) Insert two snap-fits on the top right and left edges of the cover
into the control unit.