Park Brake Handle Assembly Replacement (2012 & Later); Park Brake Handle Removal (2012 & Later) - Toro Z Master G3 3000 Series Service Manual

CHASSIS
7. Install the throttle cable under the throttle clamp.
Install the throttle Z-bend in the middle hole on the
throttle arm assembly (Fig. 064).
3
8. Move the throttle arm assembly to the low idle
position and tighten the throttle cable clamp (Fig.
065).
9. Move the throttle control back and forth checking the
operation of the throttle arm assembly.
10. Connect the negative battery cable to the battery.
3-18
Fig. 064 DSCN-4279a
Fig. 065
DSCN-4281a
Park Brake Handle Assembly
Replacement (2012 & Later)
Park Brake Handle Removal (2012 & Later)
1. Remove the two screws retaining the right hand
motion control cover assembly to the frame and
remove the cover (Fig. 066).
2. Unplug the wire harness from the park brake switch
(Fig. 067).
Toro Z Master G3 3000/5000/6000 Series Service Manual
Fig. 066 DSCN-2614a
Fig. 067 DSCN-2617a