Park Brake Handle Assembly Replacement - Toro TITAN Max Service Manual

Choke Control Assembly Installation (continued)

Park Brake Handle Assembly Replacement

Park Brake Handle Assembly Removal
Chassis: Service and Repairs
6. Place the z-bend of the choke cable in the choke plate on the engine in
the position previously noted.
7. Place the cable under the cable clamp.
8. Ensure that the choke control lever is pressed down fully and tighten the
cable clamp.
g344320
9. Install the rear guard to the main frame.
10. Install the 4 (5/16-18 x 2 3/4 inch) torx screws, 4 (5/16-18 inch) nuts, 2
(0.312-18 x 1.000 inch) carriage screws, and 2 (5/16-18 inch) nuts securing
the rear guard to the mainframe. Torque all fasteners to 24.29 ± 3.95 N
• m (215 ± 35 in-lb).
11. Connect the battery by installing the positive cable first, then the negative
cable to the battery.
12. Verify the proper function of the unit.
1. Park the machine on a level surface and disengage the PTO. Stop the engine,
wait for all moving parts to stop, and remove key. Engage the parking brake.
2. Disconnect the battery by removing the negative cable first, then the positive
cable from the battery.
3. Release the parking brake (park brake handle down).
4. Remove the left console.
5. Remove the locking cotter pin securing the upper brake linkage to the park
brake lever.
6. To completely remove the upper brake linkage, remove the locking cotter pin
from the brake shaft and remove the clevis pin. The linkage can now be
removed from the frame slot for inspection, adjustment, or replacement.
7. Remove the (0.375-16 x 1.500 inch) screw and (3/8-16 inch) flange nut from
the park brake lever assembly.
Figure 59
Left Console Removal (page 5–13)
Page 5–30 TITAN® Max Service Manual
3442-428 Rev A