Toro Z Master G3 3000 Series Service Manual page 101

HYDRAULIC SYSTEM
24. Squeeze the tabs on the brake cable and pull the
brake cable out of the slot in the cable anchor
bracket (Fig. 281).
25. Pull back the rubber boot, exposing the brake cable,
and slide the cable out of the cable anchor bracket
5
slot (Fig. 282).
5-6
Fig. 281 PICT-8655
Fig. 282
PICT-8591a
26. Release the brake cable retainer holding the brake
cable to the cradle. Pull the retainer toward the end
of the cable and push the cable through the routing
holes so the slack is on the front side (Fig. 283).
27. Repeat steps 24 – 26 on the opposite side of the
machine.
28. Pull 2 or 3 inches of cable toward the center of
the machine and release the brake cable from the
retainers on the cradle (Fig. 284).
Note: Only the left hand brake cable is installed in
the cradle retainers.
Toro Z Master G3 3000/5000/6000 Series Service Manual
Fig. 283 PICT-8592a
Fig. 284 PICT-8649a