Toro Z Master G3 3000 Series Service Manual page 106

9. Remove the floor jack.
10. Apply thread locking compound to control arm bolt
(Fig. 301).
Fig. 301
11. Install the control arm bolt and washer securing the
control arm linkage to the UHT. Torque the bolt to 10
ft-lbs. (13.55 Nm) (Fig. 302).
Fig. 302
Toro Z Master G3 3000/5000/6000 Series Service Manual
HYDRAULIC SYSTEM
12. Install the left hand brake cable retainer into the
cradle so that the retainer tab is installed in the slot
on the cradle (Fig. 303).
PICT-8643a
13. Route the left hand brake cable around the cradle
and into the cable retainers (Fig. 304).
PICT-8644a
Fig. 303 PICT-8646a
Fig. 304 PICT-8649a
5
5-11