Removing The Blades - Toro Z Master G3 3000 Series Service Manual

4. Rotate the opposite ends of the blades forward.
5. Measure from a level surface to the cutting edge of
the blades at the same position as in step 3 above.
6. The difference between the dimensions obtained
in steps 3 and 4 must not exceed 1/8" (3mm). If
this dimension exceeds 1/8" (3mm), the blade is
bent and must be replaced; refer to "Removing the
Blades" on page 6-29 and "Installing the Blades" on
page 6-30.
WARNING
A blade that is bent or damaged could break apart
and could seriously injure or kill you or bystanders.
• Always replace bent or damaged blade with
a new blade.
• Never file or create sharp notches in the
edges or surfaces of blade.
Toro Z Master G3 3000/5000/6000 Series Service Manual
MOWER DECKS

Removing the Blades

Blades must be replaced if a solid object is hit, if the
blade is out of balance, or is bent. To ensure optimum
performance and continued safety conformance of
the machine, use genuine Toro replacement blades.
Replacement blades made by other manufacturers may
result in non-conformance with safety standards.
1. Hold the blade end using a rag or thickly padded
glove.
2. Remove the blade bolt, curved washer, and blade
from the spindle shaft (Fig. 465).
A B
C
D
Fig. 465
A. Sail area of blade
B. Blade
fig. 100 G004536
C. Curved washer
D. Blade bolt
6-29
6