Toro Z Master G3 3000 Series Service Manual page 109

HYDRAULIC SYSTEM
25. While holding the lever, pull the cable threaded
end tight through the swiv el. Spin the standard nut
against the swivel (Fig. 312).
26. Try to turn the wheel hub in both directions relative
to the caliper. There should be slight movement be-
tween them; some friction/resistance is acceptable.
5
27. If there is no movement between the hub rotor and
the caliper then back off the standard nut one turn
from the swivel and repeat step 26.
28. If the hub rotor moves very freely relative to the
caliper, then tighten the standard nut one turn
against the swivel and repeat step 26.
5-14
Fig. 312 PICT-8680a
29. Once step 26 is achieved, hold the threaded rod
end with a tool and tighten the lock nut against the
standard nut. Do not allow the cable to turn when the
lock nut is tightened (Fig. 313).
B C DE F G
A
I
A. Cable anchor
B. Threaded rod
C. Push lever this direction
D. Caliper lever arm
E. Standard nut (shown
against swivel)
Toro Z Master G3 3000/5000/6000 Series Service Manual
H
Fig. 313 fig. 63 G010208
F. Lock nut
G. Pull cable threaded rod
this direction
H. Hold threaded rod with
pliers
I. Swivel (pivot head)