Uht Transmission Installation (2012 & Later Models) - Toro Z Master G3 3000 Series Service Manual

HYDRAULIC SYSTEM
UHT Transmission Installation (2012 & later
models)
1. Using the top two bolts as guides, position the UHT
transmission into the cradle and slide the unit onto
the two bolts (Fig. 354).
Note: Be careful not to damage the UHT transmis-
sion pulley. Make sure the release valve lever
is in the closed (horizontal) position.
5
2. Loosely install a nut onto each of the bolts securing
the UHT transmission to the cradle (Fig. 355).
5-28
Fig. 354 DSCN-4535a
Fig. 355 DSCN-4536a
3. Lift the UHT transmission/cradle assembly up to the
frame with a floor jack. On the side of the machine
that was serviced, loosely install two mounting bolts,
coming from the top down, through the frame and
into the UHT transmission (Fig. 356).
4. On the opposite side, ensure the cradle mounting
holes align with the mounting holes on the UHT
transmission (Fig. 357).
Toro Z Master G3 3000/5000/6000 Series Service Manual
Fig. 356
DSCN-4546a
Fig. 357 DSCN-4539a