Toro Z Master G3 3000 Series Service Manual page 102

29. On the side of the machine being serviced, remove
the bottom carriage bolt and nut securing the UHT to
the cradle (Fig. 285).
Fig. 285
30. On the side of the machine being serviced, loosen
the 2 carriage bolts and nuts located on either side
of the UHT securing it to the cradle (Fig. 286).
Fig. 286
Toro Z Master G3 3000/5000/6000 Series Service Manual
HYDRAULIC SYSTEM
31. On the side of the machine not being serviced,
remove the 3 carriage bolts and nuts securing the
UHT to the cradle (Fig. 287).
PICT-8605a
32. Position a floor jack under the cradle on the side of
the machine being serviced. Raise the floor jack to
contact the cradle (Fig. 288).
PICT-8607a
Fig. 287 PICT-8615a
Fig. 288
PICT-8617
5
5-7