Flow Test Instructions - Toro Z Master G3 3000 Series Service Manual

Flow Test Instructions

Note: The Flow Test Kit allows the dealer to easily
determine if the UHT transmission pump is
faulty by isolating the pump section from the
wheel motor (Fig. 378).
The following information describes how to
test the pump by installing the Flow Test Kit
and simulating a wheel motor load.
Warning
Portions of the procedure require testing while the
vehicle is operated in an elevated position.
Ensure vehicle is properly secured to prevent
injury to the service technician or bystanders.
Do not attempt any adjustments with the engine
running. When working around vehicle linkages,
use extreme caution.
High temperatures can be generated.
Follow all safety procedures in the vehicle owner's
manual.
Fig. 378
Part number 116-1373
Toro Z Master G3 3000/5000/6000 Series Service Manual
HYDRAULIC SYSTEM
1. Raise the rear end of the unit and install jack stands
under the tie down loops on the frame. Remove the
RH and LH wheels from the unit (Fig. 379).
2. On some units you can lift and tilt the seat to locate
the seat switch, on other units the seat must be
removed to get to the seat switch (Fig. 380).
9792_a
Fig. 379 DSCN-4311a
Fig. 380
PICT-0398a
5
5-37