Toro Z Master G3 3000 Series Service Manual page 82

13. Secure the front pump linkage assembly to the LH
motion control assembly with a bolt, washer and nut.
Note: The washer must be installed between the LH
motion control assembly and the ball joint on
the front pump linkage assembly (Fig. 216).
Fig. 216
14. Install the two bolts and nuts retaining the LH
steering handle assembly to the LH motion control
lever (Fig. 217).
Fig. 217
15. For adjustments on the control handles and the
motion control neutral lock, see "Adjusting the
Motion Control Neutral Lock Pivot" on page 3-53
and "Adjusting the Control Handle Position" on page
3-53.
Toro Z Master G3 3000/5000/6000 Series Service Manual
16. Install the 2 screws retaining the LH motion control
cover assembly (Fig. 218).
17. Start the unit, disengage the park brake lever, and
DSCN-4470a
run for about 5 minutes operating the forward and
reverse handle forward/reverse. Move the motion
control lever to the neutral position and observe the
rear tire for movement. If the rear tire creeps in the
forward position, perform a neutral adjustment. A
slight creep in reverse is allowable. See "Adjusting
the Motion Control Linkage (Neutral Adjustment)" on
page 5-34.
DSCN-4459a
CHASSIS
Fig. 218 DSCN-4454a
3
3-61