Motion Control Assembly Replacement; Motion Control Assembly Removal - Toro Z Master G3 3000 Series Service Manual

CHASSIS
4. Align the levers front to rear position by bringing the
levers together to the neutral position and slide them
until they are aligned, then tighten the bolts (Fig.
190).
3
3-54
Fig. 190 fig. 85 G009195
Motion Control Assembly
Replacement

Motion Control Assembly Removal

Note: This procedure is performed on the left hand
motion control assembly; follow the same
procedure for the right hand side.
1. Park the machine on a level surface, disengage
the PTO, turn the ignition key to OFF position and
remove the key.
2. Remove the 2 screws retaining the LH motion
control cover assembly (Fig. 191).
Toro Z Master G3 3000/5000/6000 Series Service Manual
Fig. 191 DSCN-4454