Toro Z Master G3 3000 Series Service Manual page 130

5. Start engine.
Note: Brake must be engaged and motion control
levers out to start the engine. Operator does
not have to be in the seat because of the
jumper wire being used.
6. Run engine at full throttle and release the brake.
7. Run the unit at least 5 minutes with the drive levers
at full forward speed to bring hydraulic oil up to
operating temperature.
Note: The motion control lever needs to be
in neutral while making any necessary
adjustments.
8. Bring the motion control levers into the neutral
position. Adjust pump control rod lengths by rotating
the double nuts on the rod in the appropriate
direction until the wheels do not move forward or
reverse (Fig. 376).
Note: A slight creep in reverse is acceptable.
Fig. 376
Toro Z Master G3 3000/5000/6000 Series Service Manual
HYDRAULIC SYSTEM
9. Move the motion control levers to the reverse posi-
tion and while applying slight pressure to the lever
allow the reverse indicator springs to bring the levers
back to neutral. The wheels must stop turning or
slightly creep in reverse.
10. Shut off unit. Remove the jumper wire from the wire
harness and plug connector into the seat. If the seat
was removed, install the seat.
11. Remove the jackstands and lower the unit to the
ground.
12. Raise the deck and re-install the height of cut pin.
13. Check that the machine does not creep in neutral
with the park brakes disengaged.
DSCN-4622a
5
5-35