3. Turn the spindle housing over and install the lower
bearing race into the spindle housing (Fig. 419).
Note: The wider inside diameter of the bearing race
should be facing up to accept the tapered
bearing.
Fig. 419
4. Pack the bearing with No. 2 grease and install the
bearing (Fig. 420).
Fig. 420
Toro Z Master G3 3000/5000/6000 Series Service Manual
5. Install the lower seal (Fig. 421).
Note: The open lip of the seal should be facing
outward.
DSCN-2690a
6. Using a seal driver, drive or press the seal on the
lower end of the spindle housing until the seal is
flush with the outer edge of the housing (Fig. 422).
DSCN-2691a
MOWER DECKS
Fig. 421
Fig. 422
DSCN-2692a
6
DSCN-2693a
6-13