Front Wheel Bearing Installation - Toro Z Master G3 3000 Series Service Manual

8. Remove the 2 tapered bearings from the wheel
assembly (Fig. 023).
Fig. 023
9. Drive the bearing cup out of the wheel assembly
(Fig. 024).
Fig. 024
Toro Z Master G3 3000/5000/6000 Series Service Manual

Front Wheel Bearing Installation

1. Install a new tapered bearing cup into the wheel
assembly by pressing each bearing cup into the
wheel hub so that the thicker part of the taper is
pressed into the wheel hub first. The bearing cups
should seat against the shoulder divots inside the
wheel hub (Fig. 025).
PICT-0385a
2. Pack both tapered bearings with grease (No. 2
general purpose lithium base or molybdenum
grease).
3. Install the tapered bearings into each side of the
wheel hub (Fig. 026).
PICT-0387a
CHASSIS
Fig. 025 PICT-0389a
Fig. 026 PICT-0390a
3
3-7