CHASSIS
3. Install a cotter pin through the clevis pin (Fig. 109).
3
4. Install the rubber seal over the end of the brake snap
fitting (Fig. 110).
3-30
Fig. 109
PICT-9101a
Fig. 110
PICT-9103a
5. Route the brake cable through the side hole in the
frame and down through the hole in the cradle (Fig.
111).
6. Route the brake cable from the hole in the cradle,
back to the slot of the cradle (Fig. 112).
B
E
A
E
A. Right side brake
assembly
B. Cradle
Toro Z Master G3 3000/5000/6000 Series Service Manual
Fig. 111
PICT-9105a
C
D
D
Fig. 112
cables routing #4
C. Left side brake
assembly
D. Retainer (5)
E. Hole (2)