Toro Z Master G3 3000 Series Service Manual page 92

11. Plug the clutch wire plug into the electric PTO clutch
(Fig. 249).
Fig. 249
12. Using a 1/2" drive breaker bar installed in the square
hole in the pump idler assembly, rotate the pump
idler arm counter-clockwise to allow room to install
the v-belt around the engine pulley (Fig. 250).
Fig. 250
Toro Z Master G3 3000/5000/6000 Series Service Manual
13. Using a 3/8" breaker bar, install the mower idler arm
assembly and relieve the tension on the idler arm
assembly. Install the mower drive belt around the
electric PTO clutch (Fig. 251).
DSCN-0028a
14. Install the floor pan.
15. Install the vent line to the air filter assembly (Fig.
252).
DSCN-0025a
ENGINE
Fig. 251 DSCN-0020a
Fig. 252
DSCN-0018a
4
4-9