Park Brake Handle Installation (2012 & Later) - Toro Z Master G3 3000 Series Service Manual

CHASSIS
Park Brake Handle Installation (2012 &
Later)
1. Install the left and right brake cables in the slots in
the bottom of the brake pivot assembly and install
the e-rings (Fig. 071).
3
2. Install the clevis ends of the right and left brake
cables to the parking brake handle assembly using
two clevis pins and cotter pins (Fig. 072).
3-20
Fig. 071
DSCN-2627a
Fig. 072 DSCN-2635a
3. Install two screws through the park brake handle,
two spacers, and tighten the assembly to the frame
(Fig. 073).
4. Plug the wire harness to the park brake switch.
5. Install the two screws retaining the right hand
motion-control cover assembly to the frame and
tighten (Fig. 074).
6. Operate the park brake handle to make sure
everything is moving freely.
Toro Z Master G3 3000/5000/6000 Series Service Manual
Fig. 073 DSCN-2637a
Fig. 074 DSCN-2614a