Toro Z Master G3 3000 Series Service Manual page 119

HYDRAULIC SYSTEM
6. Using a 1/2" drive breaker bar installed in the square
hole in the pump idler assembly, rotate the pump
idler arm counter-clockwise to relieve tension on the
v-belt (Fig. 338).
7. With the tension removed from the belt, remove the
5
v-belt from around the left side transmission pulley
(Fig. 339).
5-24
Fig. 338 DSCN-4504a
Fig. 339 DSCN-4508a
8. On the side of the machine being serviced, remove
the bolt and washer securing the hydro drive control
shaft (Fig. 340).
9. Pry the control arm off the square tapered shaft (Fig.
341).
Note: Be careful to not damage the trunnion shaft
seal.
Toro Z Master G3 3000/5000/6000 Series Service Manual
Fig. 340 DSCN-4510a
Fig. 341 DSCN-4515a