Toro Z Master G3 3000 Series Service Manual page 126

15. Install the L-Bracket, spring, washer, and nut on the
threaded end of the brake cable (Fig. 366).
Fig. 366
16. Install the L-Bracket with brake pin, washer, and
e-ring to the brake caliper (Fig. 367).
Fig. 367
Toro Z Master G3 3000/5000/6000 Series Service Manual
HYDRAULIC SYSTEM
17. Engage the parking brake. Measure the overall
length of the compression spring (Fig. 368). The
correct length should be between 1-1/2" and 1-9/16"
(3.8 and 4.9cm). If the spring length is within this
range, no adjustment is needed. If it is not, proceed.
A F
DSCN-4336a
A. Cable anchor
B. Hold threaded rod here F. Compression spring
C. Measure
D. Lock nut
DSCN-4314a
B C D
A
G
H
E
H
Fig. 368
(Left Hand brake shown above)
E. Caliper
G. Threaded rod
H. Hub
F E
5
fig. 79 G016879
5-31