Toro Z Master G3 3000 Series Service Manual page 107

HYDRAULIC SYSTEM
14. Pull the boot back and slide the brake cable into
the slot in the cable anchor bracket. Slide the boot
up and over the end of the cable retainer to ensure
water is sealed out (Fig. 305).
15. Repeat steps 12 and 14 to install the right hand
5
brake cable.
16. Slide the wheel hub onto the UHT shaft aligning the
keyway in the wheel hub with the key in the UHT
shaft. Loosely install the castle nut (Fig. 306).
Note: Do not use anti-seize compound on the wheel
hub.
5-12
Fig. 305 PICT-8659a
Fig. 306 PICT-8661a
17. Slide the brake cable swivel through the brake
caliper and loosely install a nut onto the swivel (Fig.
307).
18. Position the brake caliper onto the wheel hub
aligning the holes in the brake mount plate with the
mounting holes in the UHT. Slide a washer between
the UHT and the brake mount plate. Install a bolt
ensuring the washer is captured and tighten the bolt
(Fig. 308).
Toro Z Master G3 3000/5000/6000 Series Service Manual
Fig. 307 PICT-8663a
Fig. 308 PICT-8665a