Electric Pto Clutch Installation - Toro Z Master G3 3000 Series Service Manual

MOWER DECKS

Electric PTO Clutch Installation

1. Prepare the clutch bolt, spring washers (with crown
of the washers facing the bolt head), and washer
(Fig. 473).
A. Bolt
B. Spring Washer (2)
2. Install the electric PTO clutch on the crankshaft;
make sure the slot on the clutch fits on the clutch
anchor. Using the bolt, spring washers, and washer,
6
torque the clutch bolt to 55 ± 6 ft-lbs. (74.6 ± 8 Nm)
(Fig. 474).
6-32
C
B
A
Fig. 473 DSCN-0060a
C. Washer
Fig. 474 DSCN-0061a
3. Plug the clutch wire plug into the electric PTO clutch
(Fig. 475).
4. Using a 3/8" breaker bar, install the mower idler arm
assembly and relieve the tension on the idler arm
assembly. Install the mower drive belt around the
electric PTO clutch (Fig. 476).
5. Install the floor pan.
6. Remove the jack stands and lower the machine to
the ground.
7. Install the battery negative cable to the battery.
Toro Z Master G3 3000/5000/6000 Series Service Manual
Fig. 475 DSCN-0028a
Fig. 476 DSCN-0020a