Toro Z Master G3 3000 Series Service Manual page 162

12. If the front deck links do not have enough adjust-
ment to achieve accurate cut height, the single point
adjustment can be utilized to gain more adjustment.
13. To adjust the single point system, loosen the two
bolts at the bottom of the height-of-cut plate (Fig.
458).
Fig. 458
A. Bolts at the bottom of the height-of-cut plate
Toro Z Master G3 3000/5000/6000 Series Service Manual
14. If the deck is too low, tighten the single point adjust-
ment bolt by rotating it clockwise. If the deck is too
high, loosen the single point adjustment bolt by
rotating it counterclockwise (Fig. 459).
Note: Loosen or tighten the single point adjustment
bolt enough to move the height-of-cut plate
mounting bolts at least 1/3 the length of the
available travel in their slots. This will regain
some up and down adjustment on each of the
four deck links.
A
fig. 96 G017029
A. Single point adjustment bolt
MOWER DECKS
Fig. 459
A
6
fig. 97 G017036
6-25