Toro Z Master G3 3000 Series Service Manual page 163

MOWER DECKS
15. Tighten the two bolts at the bottom of the height-of-
cut plate (Fig. 460). Torque to 27-33 ft-lbs. (37-45
Nm).
Note: In most conditions, the back blade tip should
be adjusted 1/4" (6.4mm) higher than the
front.
6
A. Bolts at the bottom of the height-of-cut plate
6-26
A
Fig. 460 fig. 96 G017029
16. On both sides of the deck, measure from the level
surface to the back tip of the blade (Position B). The
measurement should read 3-1/4" (8.3cm) (Fig 461).
4
1. 3" (7.6cm) at A is
correct
2. 3-1/4" (8.3cm) at B
is correct
Toro Z Master G3 3000/5000/6000 Series Service Manual
1
2
3
Fig. 461 fig. 93 G009196
3. Measure here from
the blade tip to hard
surface
4. Measure at A & B on
both sides